2-4 Chapter 2: BIOS setup
• This function can support devices such as USB ash disk, or oppy disk
with
FAT 32/16
format and single partition only.
• DO NOT shut down or reset the system while updating the BIOS to prevent
system boot failure!
4. When the correct BIOS le is found, EZ Flash 2 performs the BIOS update
process and automatically reboots the system when done.
To update the BIOS using EZ Flash 2:
1. Visit the ASUS website (www.asus.com) to download the latest BIOS le for
the motherboard.
2. Save the BIOS le to a oppy disk or a USB ash disk, then restart the
system.
2.1.2 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having to go
through the long process of booting from a oppy disk and using a DOS-based
utility. The EZ Flash 2 utility is built-in the BIOS chip so it is accessible by pressing
<Alt> + <F2> during the Power-On Self Tests (POST).
3. You can launch the EZ Flash 2 in two ways.
(1) Insert the oppy disk / USB ash disk that contains the BIOS le to the
oppy disk drive or the USB port.
Press <Alt> + <F2> during POST to display the following.
Note
ASUSTek EZ Flash 2 BIOS ROM Utility V3.06
Current ROM
A:
FLASH TYPE: WOINBOND W25X80
PATH: A:\
BOARD: P5KPL
VER: 0123
DATE: 07/17/07
(2) Enter BIOS setup program. Go to the Tools menu then select EZ Flash2
and press <Enter>.
You can switch between drives by pressing <Tab> before the correct le
is found. Then press <Enter>.
[Enter] Select or Load [B] Backup [ESC] Exit
[Tab] Switch [Up/Down/Home/End] Move
Note
Update ROM
BOARD: Unknown
VER: Unknown
DATE: Unknown
To Next Page
Loading...
