Asus P5L-MX IPAT - 2.4.10 Super IO Configuration

2-14 Chapter 2: BIOS setup
Set Parameters of
Floppy Disk Controller
(FDC)
2.4.10 Super IO Configuration
The items in this menu allow you to set or change the congurations
for super IO devices. Select an item then press <Enter> to display the
conguration options.
Super IO Conguration
Super IO Chip Winbond W83627
Floopy Disk Controller Conguration
Serial Port Conguration
Parallel Port Controller Conguration
Floppy Disk Controller Configuration
Enable or Disable
Floppy Disk Controller
Floopy Disk Controller Conguration
Floopy Disk Controller [Enabled]
Device Settings Reset Required
Change Settings [Auto]
Device Mode [Read Write]
Floppy Disk Controller [Enabled]
Allows you to enable or disable the oppy disk controller.
Conguration options: [Disabled] [Enabled]
Change Settings [Auto]
Allows you to select an optimal settings for the super IO device.
Conguration options: [Auto] [IO=3F0h; IRQ=6; DMA=2]
[IO=3F0h; IRQ=3, 4, 5, 6, 7, 10, 12; DMA=1, 2, 3;]
Device Mode [Read Write]
Allows you to set the mode of oppy disk controller. Selects Read
Write mode for normal operation. Selects Write Protect mode for read
only operation. Conguration options: [Read Write] [Write Protect]