Asus P5W - Page 187

ASUS P5W 5-63
7. Key in the RAID volume capacity that you want then press <Enter> when
the Capacity item is highlighted. The default value indicates the maximum
allowed capacity.
8. Press <Enter> when the Create Volume item is highlighted. This warning
message appears.
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
9. Press <Y> to create the RAID volume and return to the main menu or <N> to
go back to the Create Volume menu.
10. The main menu appears as follows after you have created the RAID 10 set.
The HDD connected to the EZ_RAID connector is identied as “External
Disk.”
Intel(R) Matrix Storage Manager Option ROM v5.1.2.1002 ICH7R wRAID5
Copyright(C) 2003-05 Intel Corporation. All Rights Reserved.
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
4. Exit
[ DISK/VOLUME INFORMATION ]
RAID Volumes:
ID Name Level Strip Size Status Bootable
0 Volume0 RAID10(RAID0+1) XXKB XXX.XX GB
Normal Yes
Physical Disks:
Port Drive Model Serial # Size Type/Status(Vol ID)
0 XXXXXXXXXXX XXXXXXXX XX.XXGB
Member Disk (0)
1 External Disk 0 XXXXXXXX XX.XXGB
Member Disk (0)
2 XXXXXXXXXXX XXXXXXXX XX.XXGB
Member Disk (0)
3 XXXXXXXXXXX XXXXXXXX XX.XXGB
Member Disk (0)
[↑↓]-Select [ESC]-Exit [ENTER]-Select Menu
[ MAIN MENU ]
When you create a RAID 10 set through a cross conguration, you cannot use
the EZ-Backup Manager utility to view the status of hard disks installed on the
EZ_RAID1 and EZ_RAID2 connectors. Intel
®
Matrix Storage cannot read the
hard disk drive information on the ASUS EZ-Backup connectors.