Asus P7H57D-V EVO - Page 49

ASUS P7H57D-V EVO 2-31
Chapter 2
3. Marvell
®
Serial ATA 6.0 Gb/s connectors
(7-pin SATA_6G_1, 7-pin SATA_6G_2 [gray])
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA 6.0 Gb/s
hard disk drives.
• These connectors are set to Standard IDE mode by default. In Standard IDE mode,
you can connect Serial ATA data hard disk drives to these connectors.
• You must install Windows
®
XP Service Pack 2 or later versions before using Serial ATA
hard disk drives.
• When using hot-plug and NCQ, set the
Marvell(R) SATA6G Controller
item in the
BIOS to [AHCI Mode]. Refer to section
3.6.3 Onboard Devices Conguration
for
details.