3-26 Chapter 3: BIOS setup
Chapter 3
3.6.3 Onboard Devices Conguration
HDA Controller [Enabled]
[Enabled] Enables the High Denition Audio Controller.
[Disabled] Disables the controller.
The following three items appear only when you set the HDA Controller item to [Enabled].
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or
high-denition audio depending on the audio standard that the front panel audio
module supports.
[AC97] Sets the front panel audio connector (AAFP) mode to legacy AC’97
[HD Audio] Sets the front panel audio connector (AAFP) mode to high denition audio.
SPDIF OUT Mode Setting [SPDIF]
If your graphics card has HDMI output and needs to use SPDIF signal from the
SPDIF_Out header, you need to set to HDMI for HDMI audio output.
[SPDIF] Sets to [SPDIF Output] for SPDIF audio output.
[HDMI] Sets to [HDMI Output] for HDMI audio output.
Realtek LAN [Enabled]
[Enabled] Enables the Realtek LAN controller.
[Disabled] Disables the controller.
LAN Boot ROM [Disabled]
This item appears only when you set the previous item to [Enabled].
[Enabled] Enables the Realtek Gigabit LAN Boot ROM.
[Disabled] Disables the LAN Boot ROM.
Onboard 1394 Controller [Enabled]
[Enabled] Enables the onboard IEEE 1394a controller.
[Disabled] Disables the controller.
Marvell(R) 88SE6111 Controller [Enabled]
[Enabled] Enables the Marvell 88SE6111 controller.
[Disabled] Disables the controller.
Onboard Devices Conguration
HDA Controller [Enabled]
Front Panel Type [HD Audio]
SPDIF OUT Mode Setting [SPDIF]
Realtek LAN [Enabled]
LAN Boot ROM [Disabled]
Onboard 1394 Controller [Enabled]
Marvell(R) 88SE6111 Controller [Enabled]
Serial Port1 Address [3F8/IRQ4]
Marvell(R) SATA6G Controller [IDE Mode]
BIOS SETUP UTILITY
Advanced
Options
Enabled
Disabled