3-11ASUS PG32UCDM Series OLED Monitor
• Adjusts the OSD position.
• Adjusts the OSD timeout from 10 to 120 seconds.
• Adjusts the OSD background from opaque to transparent.
• Enables or disables the DDC/CI function.
• Screen Protection: Congures the screen saver related set up. You can
improve the image quality issues related to image retention when the
screen is on for a certain amount of time.
• Screen Saver: Enables/disables the screen saver function. The
screen brightness will automatically decrease when there is no
change on the screen.
• Pixel Cleaning: It calibrates any issues that may arise on the
screen when your monitor has been turned on for a long time.
The process will take approximately 6 minutes. This function
will automatically activate when the monitor is turned off. Do not
unplug the power cord while it is in progress. If you power on the
monitor, the Pixel Cleaning will stop operating.
• Pixel Cleaning Reminder: Enable or disable displaying pixel
cleaning reminder.
• Screen Move: Select the screen movement level to prevent image
sticking on the display panel.
• Auto Logo Brightness: Enable this function to allow the system
to automatically adjust the logo brightness to correct the potential
picture quality issues.
• DisplayPort Stream: Compatibility with graphic card. Select DisplayPort
1.2, or DisplayPort 1.4 by graphic card supported DP version.
• DSC Support: DisplayPort Display Stream Compression.
• Color Calibraion:
• Color Calibraion Report: Views the color calibration report for this
monitor.
• Information: Shows the monitor information.
• All Reset: Selecting “Yes” allows you to restore the default settings.
To Next Page
Loading...
Need help?
General
