Asus ROG SWIFT PG48UQ - Monitor Power On and Indicator

2-5
ASUS LCD Monitor PG48UQ Series
• To use the USB 3.0 ports:TakethesuppliedUSB3.0cable,andplug
thesmallerend(typeB)oftheUSBupstreamcabletothemonitor’s
USBupstreamport,andthelargerend(typeA)toyourcomputer’s
USB3.0port.Makesureyourcomputerisinstalledwiththelatest
Windows10/Windows11operatingsystem.ThatwillenabletheUSB
ports on the monitor to work.
• To use the 3.0 port for firmware upgrade:Savethenewfirmwareto
thediskdrive.Thenplugthediskdrivetothemonitor’supstreamport.
Followtheon-screeninstructionstoupgradethefirmware.
2.5 Turning On the Monitor
You can either press the button on the remote control or the button
on the monitor to turn on the monitor.
If the Power Indicator function is enabled and an input source is detected,
thepowerLEDwilllightupredtoindicatethatthemonitoristurnedon.
ThepowerLEDwillnotlightupinPowerSavingmode.