3-7
Chapter 3: General Instruction
• AudioWizard:Selectthesoundmode.
• USB Hub:SetstheUSBHubavailabilityduringstandby.
• Power Indicator:TurnthepowerLEDindicatoron/off.
• Power Key Lock:Disable/EnablethePowerkey.
• Key Lock:Enablethisfunctiontodisableallfunctionkeys.
Press the Navigation button down for more than five seconds to
cancel the key lock function.
• Power Setting:Selectthepowersettingmode.
IfthesettingissettoStandard Mode,itmayresultinhigher
powerconsumption.Ontheotherhand,ifthesettingisset
to Power Saving Mode, it may cause limited luminance
performance.
Power Setting
Standard mode setting may result in higher power consumption.
Power saving mode may cause limited luminance performance.
Would you like to switch to Standard mode?
NO
YES
• OSD Setup:ConfiguretheOSDmenurelatedsettings.
• OSD Position:SettheOSDmenuposition.
• OSD Timeout:AdjusttheOSDtimeout.
• Transparency:AdjusttheOSDbackgroundfromopaqueto
transparent.
• Zoom By Remote Control:SelecttheOSDmenusize
whenusingtheremotecontrol.
• Zoom by Hot Key:SelecttheOSDmenusizewhenusing
the Control buttons.
• DDC/CI:Enable/DisabletheDDC/CIfunction.
• Screen Protection:Configurethescreensaverrelatedset
up.Youcanimprovetheimagequalityissuesrelatedtoimage
retention when the screen is on for a certain amount of time.
• Screen Saver:Enable/disablethescreensaverfunction.
Thescreenbrightnesswillautomaticallydecreasewhen
thereisnochangeonthescreen.
• Pixel Cleaning:Itcalibratesanyissuesthatmayariseon
thescreenwhenyourmonitorhasbeenturnedonforalong
time. The process will take approximately 6 minutes. This
function will automatically activate when the monitor is turn
off.Donotunplugthepowercordwhileitisinprogress.
Ifyoupoweronthemonitor,thePixelCleaningwillstop
operating.