Asus TUF Z270 MARK 2 - HDD;SSD SMART Information

ASUS TUF Z270 MARK 2
3-19
Chapter 3
3.6.8 APM Configuration
The items in this menu allow you to set system wake and sleep settings.
ErP Ready
ThisitemallowsyoutoswitchoffsomepoweratS4+S5orS5togetthesystemreadyfor
ErPrequirement.Whensetto[Enabled],allotherPMEoptionsareswitchedoff.
Congurationoptions:[Disabled][Enable(S4+S5)][Enable(S5)]
3.6.9 Network Stack Configuration
TheitemsinthismenuallowyoutocongureIpv4/Ipv6PXEsupport.
3.6.10 HDD/SSD SMART Information
ThismenudisplaystheSMARTinformationoftheconnecteddevices.
NVMExpressdevicesdonotsupportSMARTinformation.
3.6.11 USB Configuration
The items in this menu allow you to change the USB-related features.
The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.1.2 Motherboard layout for the location of the USB ports.