Asus VT168HR Series - Detaching the Base;Stand (for VESA Wall Mount)

2-1
ASUS LCD Monitor VT168HR
2.1 Detaching the base/stand
(for VESA wall mount)
ThedetachablestandoftheLCDmonitorisspeciallydesignedforVESA
wallmount.
To detach the arm/stand:
1. Disconnectpowerandsignalcables.Carefullyputthefrontofthe
monitorfacedownonacleantable.
2. Useyourngertoloosenthescrewlocatedatthebottomofthebase,
andremovethebasefromthestand.Andthenremovethehinge
coverfrommonitorbodybyusingyourngers.
3. Useascrewdrivertoremovethefourscrewsonthearm,andthen
detachthearm/standfromthemonitor.
• Werecommendthatyoucoverthetablesurfacewithsoftclothto
preventdamagetothemonitor.
• Holdthestandofthemonitorwhileremovingthescrews.
2
1
• TheVESAwallmountkit(75x75mm)ispurchasedseparately.
• UseonlytheULListedWallMountBracketwithminimumweight/
load4.8kgaccordingtothemodellistedinthespecificationtable
(Screwsize:M4x10mm).