2.15 Parking the Machine
• Stop the machine only on an even and solid surface.
• Lower the lift arms to the frame stop and rest the bucket on the ground.
• Shut the machine down as described in section 5.13.
• Close the machine doors and windows (if equipped), remove the key to
secure the machine against unauthorized use.
2.16 Towing/Retrieving the Machine (see note below)
• Always observe the correct procedure as described in the operating
instructions.
• The machine should be towed only in exceptional cases, for example to
bring the machine away from an endangered place for repair.
• Check all trailing and drawing devices for their safety when pulling or
towing.
• Towing equipment such as ropes, etc., must be of the correct capacity and
must use at least two of the d-rings on the front or rear of the chassis.
• Pull the rope taut slowly and carefully. A sudden jerk can cause a sagging
rope or cable to tear or snap.
2 SAFETY
22
RT-60/R160T/R190T ROW O&M
0404-659 2016-05
To Next Page
Loading...
Need help?
General
