INTRODUCTION
Congratulations on your purchase of a DMP808 Automatic Mixer� The DMP808 provides a simple, effective way to
maintain your audio levels in live venues without having to keep on your toes� A single DMP808 offers twelve-in, eight-
out support and the entire unit can be controlled remotely through standard potentiometers and remote controls� Internal
processing is accomplished through a high quality 40-bit oating point processor, with internal signal processors and
matrix routing all handled with ease�
Clear, easy-to-use software on your Windows computer makes control of your onboard processing simple� The software
offers full performance monitoring for each processor, giving real-time information on the load placed upon DSPs�
We know how eager you are to get started – hooking up your new DMP808 is probably your rst priority right now – but
we would advise that you take the time to look over this manual. Inside you’ll nd important safety considerations and
operating instructions that could prove helpful� After reading the manual, we would suggest putting it somewhere easy to
nd as you will probably need to refer to it later on.
FEATURES
√ 8 input channels and 8 output channels available via 3-pin euroblock connections with 4 additional RCA inputs
√ 8 x 8 matrix mixing
√ 40-bit floating point processor with internal sampling selectable between 44.1 and 48 kHz
√ Ethernet connectivity for network control application
√ Automatic DHCP network IP configuration
√ Easy and intuitive control software from A Systems
√ User-accounts with multi-layer security
√ 4-band parametric EQs and 31-band graphic equalizers
√ Autoleveler (Loudness Control)
√ Compressors and noise gates
√ Level ducking with trigger control
√ All signal processors flexible and user-controllable
GETTING STARTED
For easy control of the DMP808, you will need to connect the device to a network-enabled Windows computer� By
installing the A Systems software on a computer will allow for remote control of this unit� Enter the DMP808’s IP address
into the PC software to locate the DMP808 on either the local area network�
Connect all necessary input and output devices� Input can be achieved through correctly wired euroblock connectors�
Wiring for balanced euroblock connectors should be as follows:
Pin 1: Shield/Ground
Pin 2: Cold (–)
Pin 3: Hot (+)
Whereas unbalanced connectors can be wired as so:
Pin 1: Shield/Ground
Pin 2: Link to Pin 1
Pin 3: Hot (+)
To Next Page
Loading...