English
a
WARNING. The manufacturer is not liable in
case of environmental polluon due to an
incorrect use of the thermodisinfector.
Ö
WARNING: For versions with spray arm
rotaon control, the spray arm with the
magnet must be posioned below (1 Fig.
10b).
Ö
WARNING: Spray arm assembly direcon,
the water outlet holes must face towards the
inside of the tank otherwise the spray arms
will NOT work.
a
Failure to comply with these
recommendaons can lead to a malfuncon
of the water soening device. Just before
the salt runs out completely, the display will
show the message «Lack of salt». At this
point, the salt should be topped-up as soon
as possible, otherwise an error message will
appear and it will no longer be possible to
acvate a new cycle if not by reseng.
To Next Page