GB 27
Ventilation
e electronics in the appliance need cooling. e appliance will
automatically switch off if there is insuffi cient air circulation. ere
are ventilation openings on the underside of the appliance. It must be
possible for cool air to be drawn in through these openings. ere are
outlet openings on the underside and at the front of the appliance.
Constructing above a load or an oven or fi xed pannel
Ventilation occurs through the plinth (A) and the back of the
cupboard (B). Saw out the ventilation openings (min. 100 cm
2
).
Air supply A is superfl uous when, together with opening B,
there’s an opening somewhere else where air can be drawn in.
Make sure the crossbar does not impede the airfl ow. Plane or saw the
crossbar C diagonally if necessary.
Do not allow a drawer to block the ventilation openings on the
bottom of the appliance. If there is a drawer under the hob, a gap of
at least the width of the hob should be made at the front. e distance
between the drawer A and the hob should be at least 10 mm.
A
C
B
GeneralINSTALLATION INSTRUCTIONS
To Next Page
Loading...
Need help?
General
