EasyManua.ls Logo

Atag KA8074K3C - Use

Atag KA8074K3C
310 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Make sure that the electrical information on the rating plate agrees
with the power supply. If not, contact an electrician.
Always use a correctly installed shockproof socket.
Do not use multi-plug adapters and extension cables.
Make sure not to cause damage to the electrical components
(e.g. mains plug, mains cable, compressor). Contact the Service
or an electrician to change the electrical components.
The mains cable must stay below the level of the mains plug.
Connect the mains plug to the mains socket only at the end of
the installation. Make sure that there is access to the mains plug
after the installation.
Do not pull the mains cable to disconnect the appliance. Always
pull the mains plug.
WARNING!
Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance
Use
WARNING!
Risk of injury, burns, electrical shock or fire.
Do not change the specification of this appliance.
Do not put electrical appliances (e.g. ice cream makers) in the
appliance unless they are stated applicable by the manufacturer.
Be careful not to cause damage to the refrigerant circuit. It
contains isobutene (R600a), a natural gas with a high level of
environmental compatibility. This gas is flammable.
If damage occurs to the refrigerant circuit, make sure that there
are no flames and sources of ignition in the room. Ventilate the
room.
Do not let hot items to touch the plastic parts of the appliance.
7
Safety instructions

Table of Contents

Related product manuals