EasyManua.ls Logo

Atag KD66178DN - Installation and Connection; Selecting the Location

Atag KD66178DN
122 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Selecting the location
Place the appliance in a dry and well aired room. The permitted
ambient temperature range for the appliance depends on the
appliance's climate class, which is shown on the type plate.
Do not place the appliance near a source of heat, such as a gas cooker, radiator or boiler, etc.,
and do not expose it to direct sunlight.
Relative humidityAmbient temperature range °CClassDescription
75%
+10 to +32SNExtended temperate
+16 to +32NTemperate
+16 to +38STSubtropical
+16 to +43TTropical
WARNING!
Do not place the appliance in a room where the temperature can fall below the lowest permitted
ambient temperature: the appliance may not work properly!
WARNING!
Do not place the appliance in a room where the temperature can fall below 5 °C: the appliance
may not work properly or become defective!
WARNING!
The appliance is not suitable for outdoor use and it may not be exposed to rain.
The appliance must be placed at a distance of at least 5 cm from an electrical or gas cooker
and at least 30 cm from a radiator or heater. An insulation panel must be fitted when these
distances cannot be kept.
The appliance must be placed at a distance of about 5 cm from the wall, back and sides of a
cupboard. A kitchen cupboard above the refrigerator must have a gap of at least 5 cm between
the back of the cupboard and the wall. This is needed to make sure that there is sufficient cooling
air for the condenser.
The plug of the installed appliance must remain accessible!
10
Installation and connection

Table of Contents

Related product manuals