Atag MadQ/2 - Info-Time Display Settings; Managing Display Duration

3)
indicates the function of the outputs
– Unmixed circuit pump (HC-P)
– Variable output VO1 (only MadQ 233BVVC)
– Variable output VO2 (only MadQ 233BVVC)
– DHW-circulation pump
– Transport pump
– Boiler pump 1
– Boiler pump 2
– Timer
Page GB-13
OOFFFF
DDHHWW
AAUUTTOO--PP11 DDAAYY
Domestic hot water circuit
1)
1144..55
RROOOOMM TTEEMMPP HHCC
°C
Room temperature
Unmixed circ.
(only in conn. with room sensor)
OONN
CCCC
OOUUTTPPUUTT HHCC--PP
Unmixed circuit pump
3)
----
RROOOOMM TTEEMMPP MMCC11
Room temperature
Mix. valve 1
(only in conn. with room sensor)
----
RROOOOMM TTEEMMPP MMCC22
Room temperature
Mix. valve 2
(only in conn. with room sensor)
Info-time
The standard display will appear after a set time if no key is pressed. It is pos-
sible to have the information shown permanently using a fastkey or to adjust
the display time (except for the general exit time SYSTEM - Parameter 11):
- press the i-key for 3 seconds
- INFO TIME (= duration of the information in the display) will appear
- Turn the rotary pushbutton to the desired value.
- Press the rotary pushbutton.
- The selected value is activated.
Setting range: OFF (permanent display of selected information)
0.5 to 10 minutes
Application: Permanent display of selected infor-
mation (monitoring)
* Outside temperature is only displayed when the outside sensor is connected.
GB
8A521100_GB.qxd 10.11.2004 12:05 Seite 13