HEATINGEND
selected cycle
TEMPERATURE
selected cycle
DAY/
MONTH
TIMECHANGE
SUMMER - WIN-
TER
HEATINGSTART
selected cycle
Parameter 03
CONTROL MODE
common (1)
separate (2)
Parameter 04
SUMMERSHUT-
DOWN
Heating limit
RESET
Factory setting
reactivate
back forward
back forward
back forward
back forward
back forward
Page GB-15
Parameter 11
RETURN TO
STANDARD DISPLAY
back forward
Selection and modification of parameters
and setting values
When entering the programming level, the TIMEPROGRAMS-level will always
appear first. All other levels can be selected with the rotary pushbutton (if neces-
sary after entering the required code).
The selected and flashing level is activated by touching the rotary pushbutton, the
first value or parameter flashes. If necessary, it can be changed by means of the
rotary pushbutton and subsequently accepted by quickly pressing the button once
again. If necessary, the other parameters should be treated in the same way.
Return to the previous step by means of button
¤¤
, return to standard display by
means of button
¢¢
or automatically after approx. 60 seconds.
GB
8A521100_GB.qxd 10.11.2004 12:05 Seite 15
To Next Page
Loading...
Need help?
General