CARE AND CLEANING
Warning! Before maintenance,
deactivate the appliance and
disconnect the mains plug from the
mains socket.
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if neces-
sary, clean them.
Cleaning the filters
C
B
A
1.
Turn the filter (A) counterclockwise and
remove it.
A1
A2
2.
To disassemble the filter (A), pull apart
(A1) and (A2).
3.
Remove the filter (B).
4. Wash the filters with water.
5.
Put the filter (B) to its initial position.
Make sure that it assembles correctly
under the two guides (C).
6. Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
26
To Next Page
Loading...
