How to troubleshoot Atag VA5511BT that doesn't start?
If your Atag Dishwasher doesn't start or stops mid-cycle, ensure the mains plug is securely connected to the socket and check the fuse box for any damaged fuses.
What to do if Atag VA5511BT programme does not start?
If the program on your Atag Dishwasher isn't starting, make sure the appliance door is fully closed. Also, if the delay start function is activated, either cancel the setting or wait for the countdown to finish.
Why my Atag Dishwasher does not fill with water?
If your Atag Dishwasher isn't filling with water, several factors could be the cause. First, ensure that the water supply pressure is adequate. Next, check that the water tap isn't clogged and that the filter in the inlet hose is clean. Finally, make sure the inlet hose isn't kinked or bent.
Why are the dishes wet in my Atag Dishwasher?
If dishes are wet after a cycle in your Atag Dishwasher, it could be due to several reasons. The selected program might lack a drying phase or use a low-temperature drying phase. Check if the rinse aid dispenser is empty or if the rinse aid quality is poor. Also, the quality of the combi detergent tablets could be the issue; try using a different brand.
What to do if Atag VA5511BT Dishwasher does not drain?
If your Atag Dishwasher isn't draining water, check to ensure that the sink spigot isn't clogged and that the drain hose isn't kinked or bent.
Why are there streaks on dishes from Atag Dishwasher?
If you observe whitish streaks or bluish layers on glasses and dishes after using your Atag Dishwasher, adjust the rinse aid selector to a lower position. It's also possible that you're using too much detergent.
What to do if anti-flood device is on in Atag VA5511BT?
If the anti-flood device on your Atag Dishwasher is activated, close the water tap and contact the Service.
General| Type | Freestanding |
|---|---|
| Water consumption | 9.5 L |
| Delay start | Yes |
| Child lock | Yes |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
To Next Page
