21
Drain pump
The pump can be accessed from inside the
machine.
1. Cut the power to the machine by pulling out
the plug!
2. Remove the coarse lter and pipe section.
3. Remove the small tted piece at the left of
the bottom drain (see the image below).
4. You can release and turn the pump blade by
inserting your nger into the hole and release
anything blocking it.
5. Reinstall the tted piece and lters.
6. Plug the plug into the wall socket.
If the machine still does not start and a buzzing
sound is heard, the overow guard has been
activated.
• Shut o the water.
• Pull the plug out from the wall socket.
• Call the service division.
NOTE!
Do not forget to reinstall the tted piece.
The spray arms
Holes and bearings can sometimes become
blocked.
1. Pull the lower washer arm straight up to
release it.
2. Remove any deposits using a needle or simi-
lar.
The washer arms also have holes under neath.
Cleaning
To Next Page
Loading...
