25
Setting a signal
If you want the machine to signal when the wash is complete, you can program it to do this. The
machine is set without a signal by default.
1. Switch o the dishwasher at the main switch.
2. Hold in the Delayed start button at the same time as you press the
main switch. The button ashes. Release the button.
PROG
PROG
3. Press the Program button – when the Daily wash symbol lights, the
signal is activated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next
time you want to make a change.
or Reset
1. Switch o the dishwasher with the main switch.
2. Hold in the Delayed start button at the same time as you press the
main switch. The button ashes. Release the button.
PROG
PROG
3. Press the Program button – when the Daily wash symbol goes out, the
signal is deactivated.
START
STOP
4. Press the Start/Stop button and the setting will be stored until next
time you want to make a change.
Settings
To Next Page
Loading...
