OptionsSettings
Setting for rinse aid dosage. The rinse aid dispenser can be
adjusted between 0 (Off) and 5 (High dosage).
0/1/2/3/4/5/TABRinse aid7.
Increase the rinse aid dosage:
• If the dishes have water marks.
Decrease the rinse aid dosage:
• If the dishes have a sticky white/blue film.
• If the dishes are streaked.
• Build-up of foam. If you have very soft water, the rinse aid can
be diluted 50:50 with water.
When using an all-in-one detergent that contains rinse aid, you can
activate the setting TAB.
Super rinse adds two extra rinses.On/OffSuper rinse8.
Activated in the following programmes:
Normal wash
ECO wash
Daily wash
Plastic wash
Lower half wash
Upper half wash
Activate the setting High temperature to improve the dishwashing
results. Energy consumption is slightly increased.
On/OffHigh temperature9.
Activated in the following programmes:
Normal wash
ECO wash
Daily wash
Plastic wash
Quick Pro wash
Lower half wash
Upper half wash
Built-in water tank.On/OffWater save10.
Before deactivating the water tank, run a self-cleaning programme.
See Self-cleaning in the chapter Using the dishwasher.
Adjusting the water softener. Read off the appropriate setting from
the water hardness table below.
°dH
0-5
6-8
9-11
12-14
15-19
20-24
25-29
30-39
40-49
50+
0-9
10-14
15-20
21-25
26-34
35-43
44-52
53-70
71-88
89+
°fH
°dH
°fH
0/1/2/3/4/5/6/7/8/9Water hardness11.
Do not forget to put salt in the salt compartment after you have set
the water softener to 1 - 9.
For a water supply with a hardness under 6°dH (9°fH), select 0.
The water softener is deactivated and no salt is needed.
13
To Next Page
Loading...
