Alarms and Trouble Beeps
NOTE: If AC
Power
is the only indicator light on, the device shown in the
display is NOT
SECURE-it
may be disarmed or its sensor may be open.
This will not cause trouble beeps, but the Central Controller will beep four
times when you try to set your system to HOME or AWAY.
5
Press Messages again to check for additional problems. The system will
display additional trouble messages, if there are any, each time you
press Messages.
When the digital display shows -A, -0, or
-H,
(Away, Off, or Home), you
have seen all the trouble messages. To run through them again, press
Messages.
6
Press Messages until the display shows -A, -0, or
-H.
This will silence the
trouble beeps unless the system detects a new problem. The trouble
messages will stay in the Central Controller memory until you clear
them.
7
After you have corrected the problem, press Clear Display to erase the
trouble messages shown in the digital display. Trouble messages can
only be erased if the problem has been fixed.
16
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General