6 Connect the power cord.
CAUTION:Use only the power cord supplied with your
system.If you need a replacement cord,call 1 800 222-3111.
Fit the power cord behind the strain relief tab. Then plug the
smaller end of the power cord into the jack labeled POWER at the
back of the system. Plug the power cord into a standard electrical
outlet not controlled by a wall switch.
7 System self-test.
As soon as you connect the power cord,the system runs a quick
self-test.
8 Check for dial tone.
Press L,then lift the handset or press S and listen for a
dial tone. Then press l. If you do not hear a dial tone,see
IN CASE OF DIFFICULTY.
9 Confirm Lines 1 and 2.
Press L and call one of your phone numbers. If you hear a
busy signal,you called Line 1. If you hear a ringing signal in the
receiver,then you called Line 2.
10 Remove the label covering the display screen.
11 Select Display Language.
The screen displays ENGLISH (flashing) and ESPANOL (the flashing
language is the selected language). Use + or - to select the other
language,then use the softkey to select OK.
12 Program Home Area Code.
You must program your area code so your phone can properly
recognize and dial calls.
If for calls You dial Enter
within your 7 digits Your area
own area code (phone number,no area code) code
10 digits 0 0 0
(area code + phone number)
— OR —
11 digits
(1 + area code + phone number)
NOTE: You must store a Home Area Code, or the screen will
continue to display the language selection screen, and will be
unable to display Caller ID Information.
INSTALLATION
9
To Next Page
Loading...
Need help?
General
