Answering system
75
5. Press qCID or pDIR to scroll and choose among 2, 3, 4, 5, 6 or Toll saver.
• Toll saver - the answering system answers a call aer two rings when
you have new messages, and aer four rings when there are no new
messages. This feature allows you to check for new messages and avoid
paying long distance charges when calling from out of your local area.
6. Press MENU/SELECT to save the setting. You hear a conrmation tone.
Press OFF/CANCEL to cancel.
NOTES:
f If you subscribe to voicemail service through your telephone service provider, see Answering system and
voicemail indicators on page 77.
f If you set the number of rings for the answering system as two or three rings, the caller ID announce feature may
not have enough time to announce the caller’s full information.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting.
Answering system settings
Remote code
19
ECO
Remote code
ECO
Ans sys setup
ECO
To Next Page
Loading...
Need help?
General
