Answering system
74
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be heard over
the telephone base speaker when they are being recorded. If you turn call
screening on, you hear the incoming message. While monitoring an incoming
message, you can answer the call by pressing PHONE/FLASH or /SPEAKER
on the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press
MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press
MENU/SELECT.
4. Press MENU/SELECT to select Call screening.
5. Press qCID or pDIR to choose On or Off.
6. Press MENU/SELECT to save the setting.
NOTE: For more information on call screening, see pages 78-79.
Number of rings
You can set the answering system to answer an incoming call aer 2, 3, 4, 5, or
6 rings. You can also select toll saver, which is explained, as below. Unless you
change it, the answering system answers an incoming call aer three rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then press
MENU/SELECT.
4. Press qCID or pDIR to scroll to
#
of rings, then press
MENU/SELECT.
Answering sys
ECO
Ans sys setup
ECO
Call screening
ECO
3
ECO
# of rings
ECO
To Next Page
Loading...
Need help?
General
