Step 4 - Connect Router to Ethernet Circuit
Connect your Ethernet circuit using the Grey Ethernet cable to the
Ethernet WAN port pictured below.
7
RJ45 Cable labelled ISE1015-025
To Ethernet
Circuit
termination
device
Note: The Ethernet WAN port on the router example is for electrical Handoff. Should
your solution require optical handoff you will connect the fiber cable to the included SFP
module and insert into the SFP slot depicted to the right of the example above.
© 2014 AT&T Intellectual Property. All rights reserved. AT&T, Globe logo and other marks are trademarks of AT&T Intellectual Property.
To Next Page
Loading...
