8
Getting started
Installation options
Wall-mount to tabletop installation
To change the telephone base from the wall-mount position to tabletop
position, follow the steps.
Slide the telephone base upwards, then remove the telephone from the
wall-mounting plate.
1.
Unplug the large end of the power adapter from the electrical outlet.
Remove the power adapter cord from the slot. Unplug the smaller end from
the power jack on the bottom of the telephone base. Unplug the telephone
line cord from the wall jack and the telephone base. Untie the bundled
telephone line cord.
Li the handset and place it aside. Hold down the switch hook on the
telephone base, then slide the handset tab upwards to remove it from the
slot. Rotate the handset tab 180 degrees. Push the handset tab down into
the slot so it clicks into position.
2.
3.
Switch hook
Handset tab
To Next Page
Loading...
