6
Connect the handset to the telephone.
Plug the coiled handset cord into the handset jack on the left side of the
telephone base. Plug the other end of the coiled cord into the handset, then
hang up.
4.
Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial tone,
press VOLUME . If you still do not hear a dial tone, see the Troubleshooting
section on pages 30-31 of this manual.
Your telephone will work immediately after installation using the default
feature settings (see default settings in Feature summary on page 14).
5.
NOTE: If you subscribe to caller ID services from your telephone service
provider, you must follow the instructions in Set home area code (see page
11), for your telephone to properly recognize and dial calls from the call
history list. You may also need to check Set local area code (see page 12) if
you want the telephone to recognize multiple area codes.
Getting started
To Next Page
Loading...
Need help?
General
