Answering system
28
Message playback
To listen to messages at the telephone base:
Press /PLAY/STOP. Press /PLAY/STOP again to end the message
playback.
To listen to messages on a cordless handset:
1. Press MENU/SELECT when the handset is not in use.
2. Select >Play messages.
If there are new and old messages, Select >Play new msgs or >Play
old msgs.
If there are only new or only old messages, they will play automatically.
Options during playback
When messages are playing on the telephone base:
Press q/VOL/p to adjust the message playback volume.
Press /S�IP to skip to the next message.
Press /REPEAT to repeat the message. Press twice to hear the previous
message.
Press X/DELETE to delete the message.
Press /PLAY/STOP to stop playback.
When messages are playing on the handset:
Press PHONE/FLASH to stop playback. The screen shows Call back?, then
press MENU/SELECT, PHONE/FLASH, or /SPEA�ERSPEA�ER to call back the
caller if the caller’s number is available. If the dialing format used is not
correct, then use the following option to choose the correct dialing format
before calling back the caller.
Press MENU/SELECT to pause playback and show the caller ID information
if available. From here, you can press OFF/CANCEL to resume playback,
press # (pound key) to show different dialing options (page 20), or press
PHONE/FLASH or /SPEA�ERSPEA�ER to call back the caller. If you do not call
back within 10 seconds, message playback resumes automatically.
Press qCID/VOLUME or pDIR/VOLUME to adjust the message playback volume.
Press EQ to adjust the message playback audio quality.
Press 6 to skip to the next message.
Press 4 to repeat the message. Press twice to hear the previous message.
Press MUTE/DELETE to delete the message.
Press 5 to stop the playback.
Press /SPEA�ERSPEA�ER to switch between speakerphone mode and handset mode.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
