AT&T CL82401 Abridged User Manual

4
Getting started
Battery installation and charging
Once you have installed the battery, the screen indicates the battery status
(see the following table). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged
after 10 hours of continuous charging. See the table in the Technical
specifications section on page 47 for battery operating times.
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and (flashing).
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
(flashing).
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged, place it in the
telephone base or charger when not in use.
BY 1021
BT183342/BT283342
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert the
supplied battery with
the label THIS SIDE UP
facing up, as indicated.
Step 2
Align the cover flat against
the battery compartment,
then slide it upwards until
it clicks into place.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The CHARGE light on the
top of the handset is on during charging.
IMPORTANT INFORMATION
1. Use only the supplied rechargeable battery or
replacement battery (model BT183342). To order, visit
our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial
1 (866) 288-4268. For more detailed instructions,
refer to the online Complete user’s manual at
www.telephones.att.com/manuals.
2. If you do not use the handset for a long time, disconnect
and remove the battery to prevent possible leakage.
CHARGE light

AT&T CL82401 Specifications

General

Brand	AT&T
Model	CL82401
Category	Cordless Telephone
Language	English