Answering system
Message playback
When messages are playing on the handset:
Press qCID/VOLUME or pDIR/VOLUME to adjust the message
playback volume.
Press EQ to adjust the message playback audio quality.
Press 6 to skip to the next message.
Press 4 to repeat the message. Press twice to hear the previous message.
Press MUTE/DELETE to delete the message.
Press 5 or
OFF/CANCEL to stop the playback.
Press /SPEAKERSPEAKER to switch between speakerphone mode and
handset mode.
Press
PHONE/FLASH to stop playback. The screen shows Call back?,
then press MENU/SELECT,
PHONE/FLASH, or /SPEAKERSPEAKER to call back the
caller if the caller’s number is available. If the dialing format used is not
correct, then use the option, as mentioned below, to choose the correct
dialing format before calling back the caller.
Press MENU/SELECT to pause playback and show the caller ID information
if available. From here, you can press # (pound key) repeatedly to show
the desired dialing option (page 73), then press
PHONE/FLASH to call
back the caller. You can also press
OFF/CANCEL to resume playback.
If you do not call back within ten seconds, message playback resumes
automatically.
NOTE: The equalizer stays on the same settings until you change it by pressing EQ .
•
•
•
•
•
•
•
•
•
97
To Next Page
Loading...
Need help?
General
