Call block
Call block
Add a call block entry
1. When the telephone base is in idle mode, press MENU/SELECT.
2. Press qCID or pDIR to scroll to Call block, then press MENU/SELECT.
3. Press MENU/SELECT to choose Block list.
4. Press qCID or pDIR to scroll to Add new entry, then
press MENU/SELECT.
5. Use the dialing keys to enter a telephone number
(up to 30 digits) when prompted.
Press qCID or pDIR to move the cursor to the left
or right.
Press X/DELETE to erase a digit.
Press and hold X/DELETE to erase all digits.
Press and hold REDIAL/PAUSE to enter a three-
second dialing pause (a p appears).
-OR-
Copy a number from the redial list by pressing REDIAL/PAUSE, then qCID,
pDIR, or pressing REDIAL/PAUSE repeatedly to locate the number.
Press MENU/SELECT to copy the number.
6. Press MENU/SELECT to move on to the name.
The display shows Number already saved if the number is already in
the call block list. You cannot save the same number twice.
7. Use the dialing keys keys to enter a name (up to 15 characters) when
prompted. Press a key repeatedly until the desired character shows on
the screen.
Press qCID or pDIR to move the cursor to the left or right.
Press 0 to add a space.
Press X/DELETE to erase a character.
Press and hold X/DELETE to erase all characters.
Press TONE to change the next letter to upper or lower case.
8. Press MENU/SELECT to store your call block entry.
•
•
•
•
•
•
•
•
•
•
>Block list
Calls w/o num
p
q
Caller ID log
>Call block
p
q
Review
>Add new entry
p
q
77
To Next Page
Loading...
Need help?
General
