Telephone operation
44
Options while on calls
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to touch-tone
dialing temporarily during a call. This is useful if you need to send touch-tone
signals to access your telephone banking or long distance services.
1. During a call, press TONE .
2. Use the dialing keys to enter the desired number. The telephone sends
touch-tone signals.
3. The telephone automatically returns to pulse dialing after you end the call.
Blind transfer
While on an outside call, you can transfer the call to a specific device or any
device without notifying them.
To transfer an outside call from a handset:
1. During the call, press MENU/SELECT.
2. Press MENU/SELECT to choose Transfer.
If you have one handset and no other registered devices,
the outside call is put on hold and your handset shows
Transferring call.... The telephone base rings and shows
Transfer from HANDSET X.
If you have other registered device(s) or more than one
handset, your screen shows TRANSFER TO:. Use the
dialing keys to eenter a specific device number (0 for the
telephone base, 1-9 for handsets 1-9, TONE followed
by 0-2 for handsets 10-12, or TONE followed by #
for all devices), or presspress qCID or pDIR to scroll to the
desired device and press MENU/SELECT. The outside
call is put on hold and your handset screen shows
Transferring call... or Transferring call to all.... The
other device rings and shows Transfer from HANDSET X (HANDSET
represents the handset name, X represents the handset number).
3. To answer the call on the destination handset, press, press
PHONE/FLASH or
/SPEAKERSPEAKER. To answer the call on the telephone base, pressTo answer the call on the telephone base, press, press
/SPEAKERSPEAKER. The initiating handset shows Call transferred and goes to
idle mode.
•
•
>Transfer
Intercom
TRANSFER TO:
>Handset 2
Phone 0:00:12
6:30
AM
8/06
To Next Page
Loading...
Need help?
General
