10
Getting started
Battery installation and charging
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement battery (model BT183342/
BT283342). To order, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
If you do not use the handset for a long time, disconnect and remove the battery
to prevent possible leakage.
•
•
SET DATE
MM/DD/YY
SET TIME
HH:MM --
Step 3
Charge the handset by placing it face forward
in the telephone base or charger. The CHARGE
light on the handset is on during charging.
Step 2
Align the cover flat against the battery compartment, then slide it upwards
until it clicks into place.
After you install your telephone or power returns following
a power outage, the handset and telephone base will prompt
you to set the date and time. For instructions, see
Set date/time on page 16 or page 27. To skip setting the
date and time, press
OFF/CANCEL on the handset or
CANCEL on the telephone base.
After the date and time setting is done or skipped, the
telephone base will prompt if you want to set up the
answering system. Press MENU/SELECT to start the
answering system setup via voice guide. For more details,
see Voice guide on page 85. To skip the setup, press
CANCEL on the telephone base.
Voice guide to
set up Ans sys?
CHARGE light
To Next Page
Loading...
Need help?
General
