AT&T CL84202 - Page 44

Telephone operation
38
Options while on calls
To transfer an outside call from the telephone base:
1. During the call, press MENU/SELECT.
2. Press MENU/SELECT to choose >Transfer.
If your have one handset, the outside call is put on
hold and the telephone base shows
Transferring call... The handset rings and shows
Transfer from BASE 0 (BASE represents the
base name).
If you have more than one handset, the telephone
base shows TRANSFER TO: Use the dialing keys to
enter a specific handset number (1-9 for handsets
1-9, TONE followed by 0-2 for handsets 10-12, or
TONE followed by
#
for all handsets), or press qCID
or pDIR to scroll to the desired handset and press MENU/SELECT. The
outside call is put on hold and the telephone base shows Transferring
call... or Transferring call to all... The other handset(s) rings and shows
Transfer from BASE 0 (BASE represents the base name).
3. To answer the call on the destination handset, press, press PHONE/FLASH or
/SPEAKERSPEAKER. The telephone base shows Call transferred and goes to
idle mode.
NOTES:
To cancel the transfer and return to the external call before the blind transfer call is
answered, press OFF/CANCEL, PHONE/FLASH or /SPEAKER on your handset, or
CANCEL or /SPEAKER on your telephone base.
If the other device does not answer the transfer within 30 seconds, the transfer ends and the
initiating device rings while showing No response to transfer. If it does not pick up within 30
seconds, the device returns to idle mode and the outside call ends.
•
•
•
•
06:30
AM
8/06
Speaker 0:00:12
>Transfer
Intercom
p
q
TRANSFER TO:
>Handset 2
p
q