Answering system
69
Answering system settings
Answer on/off
By default, the answering system is on and ready to record messages. You
can turn the answering system off, but if you do so, the answering system
does not answer calls and record incoming messages.
To turn the answering system on or off:
Using a cordless handset:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Answer ON/OFF, then
press MENU/SELECT.
4. Press qCID or pDIR to highlight >On or >Off, then
press MENU/SELECT to save the setting. You hear a
confirmation tone.
When the answering system is on, the handset shows
ANS ON.
Using the telephone base:
Press /ANSWER ON to turn the answering system
on or off. If the answering system is turned on, it
announces, “Calls will be answered.” If the answering
system is turned off, it announces, “Calls will not be
answered.”
-OR-
1. When the telephone base is in idle mode, press
MENU/SELECT to enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Answer ON/OFF, then press MENU/SELECT.
4. Press qCID or pDIR to highlight >On or >Off, then press MENU/SELECT to
save the setting. You hear a confirmation tone.
NOTE: If the answering system is off and there is an incoming call, the system answers
after 10 rings and announces, “Please enter your remote access code.” For more
information about remote access, see page 83.
•
Play messages
>Answering sys
p
q
Record memo
>Answer ON/OFF
p
q
ANSWER ON/OFF
>On
p
q
To Next Page
Loading...
Need help?
General
