52
Answering system
Message playback
If you have new messages, you hear only the new messages in chronological
order. If there are no new messages, the system plays back all the messages
(in chronological order).
When playback begins, the total number of messages is announced. Before
each message, you hear the day and time of the recording. If the date and time
are not set, you hear, “Time and date not set,” before playback. After the last
message, you hear, “End of messages.” If the recording time is less than three
minutes, you hear, “Less than three minutes to record,” (see Message capacity
on
page 50).
To listen to messages at the telephone base:
Press
/PLAY/STOP on the telephone base to listen to the messages. The
system announces the number of messages,
To listen to messages on a cordless handset:
1. When the handset is in idle mode, press MENU/SELECT to enter the
main menu.
2. Press MENU/SELECT again to select >Play messages.
If there are new and old messages, press q
CID or pDIR to select >Play
new msgs or >Play old msgs, then press MENU/SELECT.
If there are only new or only old messages, they will play automatically.
The system announces the number of messages, then begins playback. The
message sequence is shown on the handset screen. If there are no recorded
messages, the handset screen shows No message and you hear, “You have
no message.”
Options during playback
When a message is playing, you can adjust the playback volume, skip, repeat or
delete the message.
When messages are playing on the telephone base:
Press q/VOL/p to adjust the message playback volume.
Press
/S�IP to skip to the next message.
Press
/REPEAT to repeat the message. Press twice to hear the
previous message.
Press
SLOW
to slow down the message playback
Press X/DELETE to delete the message.
Press
/PLAY/STOP to stop the playback.
•
•
•
•
•
•
•
•
To Next Page
Loading...
