39
Answering system operation
Message counter
Message counter displays
The message counter usually displays the total
number of memos and incoming messages. See the
list below for explanations of other displays in this
counter.
Message counter displays
No messages.
(flashing) The clock needs to be set. (page 34)
Total number of messages and memos, or
message number currently playing.
(flashing) Total number of messages and memos.
The number flashes when there are new
(un-reviewed) messages.
After a power failure, the number in the
message counter will flash to indicate the
clock needs to be set.
Current remote access code while setting
(page 36).
(counting) Elapsed time while recording a memo
(page 38) or announcement up to 90
seconds (page 35).
(flashing) Memo recording has reached its maxi-
mum recording time.
(flashing) Memory is full. Messages must be deleted
before new messages can be recorded.
System is answering a call, being
accessed remotely, or the clock is being
set.
(flashing) System is being setup, initialized or mes-
sages are being deleted.
or Displayed for two seconds when any
answering
system setting is turned on or off.
Current number of rings while setting
(page 36).
Displayed for two seconds while tel-
ephone base speaker volume is being
adjusted.
Displayed for two seconds while the
telephone base ringer volume is being
adjusted.
To Next Page
Loading...
