AT&T EL51203 - Wall-Mount to Tabletop Installation

Getting started
11
Wall-mount installation
Wall-mount to tabletop installation
To change the telephone base from wall-mount installation to tabletop
installation, follow the steps below.
If the telephone line cord and power adapter cord are bundled, untie
them first.
Push the telephone base up to detach it from the wall-mount bracket.
Unplug the telephone line cord (or DSL filter) from the wall. Unplug the
power adapter from the power outlet.
Push the wall-mount bracket up to remove it from the wall.
Refer to Telephone base and charger installation on page 6 to install the
telephone base.
1.
2.
3.
4.