5
Battery charging
Once you have installed the battery, the screen indicates the battery
status (see the following table). If necessary, place the handset in
the telephone base to charge the battery. For best performance,
keep the handset in the telephone base when not in use. The
battery is fully charged after 10 hours of continuous charging. See
page 32 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows LOW BATTERY until you have charged the
battery without interruption for at least 30 minutes. The following table summarizes the
battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
PLACE IN CHARGER.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
until the screen shows
LOW BATTERY or HANDSET 1
(at least 30 minutes).
The screen shows
LOW BATTERY and flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
until the screen shows
HANDSET 1 (at least
30 minutes).
The screen shows HANDSET 1
and the battery icon shows
, or .
The battery is charged. To keep the battery charged,
place it in the telephone base
when not in use.
notes:
If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
When you place the handset in the telephone base and no battery is installed in that handset,
the CHARGE light is off and the screen shows NO BATTERY. Follow the instructions in Battery
installation on page 4 to install the battery.
•
•
HANDSET 1
16 MISSED CALLS
10:30PM
11/20
Battery status icon
To Next Page
Loading...
Need help?
General
