70
Answering system
Remote access
You can access the answering system remotely by dialing your home telephone
number from any touch-tone telephone.
Remotely access the answering system
1. Dial your telephone number from any touch-tone telephone.
2. When the answering system answers, enter the 2-digit remote access code
(19, by default; refer to Remote access code on page 59). The answering
system automatically announces the number of messages (new or old) if
there are any.
3. If there are new messages, the answering system automatically begins to
play all new messages only.
-OR-
If there are no new messages, the answering system automatically begins
to play all old messages.
4. You can also enter the remote commands:
1
Press to listen to all messages. If there are new messages, the
system plays only the new messages (in chronological order). If
there are no new messages, the system plays all old messages
(in chronological order).
2 Press to listen to new messages only.
3 Press during message playback to delete the current message.
33 Press to delete all old messages.
4
Press 4 to repeat the playing message.
Press 4 twice to listen to the previous message.
5 Press to stop playback and recording.
5 Press to listen to a list of remote commands.
6
Press during playback to skip the current message and advance
to the next message.
7
Press to record a new announcement. Begin speaking aer the
long beep.
8 Press to end remote access (the call ends).
0 Press to turn the answering system on or o.
To Next Page
Loading...
Need help?
General
