AT&T EL52310 - Call Operations; Making a Call; Answering a Call; Ending a Call

10
Making, answering and ending calls
Making a call
Press PHONE/FLASH or SPEAKER and then dial a telephone
number, or predial by rst dialing the number and then pressing
PHONE/FLASH or SPEAKER. When entering the number
before pressing PHONE/FLASH or SPEAKER, you can:
Press and hold REDIAL/PAUSE to insert a three-second dialing
pause (a P appears).
Press MUTE/DELETE to make corrections.
Press and hold OFF/CLEAR to return to the idle mode.
The screen shows the elapsed time as you talk (in hours, minutes
and seconds).
Answering a call
Press PHONE/FLASH, SPEAKER, or any dial pad key (known as Any Key Answer).
Ending a call
Press OFF/CLEAR or put the handset in the telephone base or
charger to end the call (known as Auto O).
Speakerphone
During a call, press SPEAKER to switch between speakerphone and normal handset
use. Press OFF/CLEAR to hang up.
Temporary ringer silencing
While the telephone is ringing, press OFF/CLEAR or MUTE/DELETE to silence the ringer
temporarily on that handset only. This turns o the ringer without disconnecting the
call. The next incoming call rings normally at the preset volume.
•
•
•