AT&T EL52310 User Manual

5
Battery charging
Once you have installed the battery, the screen indicates the
battery status (see the following table). If necessary, place the
handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the telephone base or
charger when not in use. The battery is fully charged aer 10 hours
of continuous charging. See page 33 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows LOW BATTERY until you have charged the
battery without interruption for at least 30 minutes. The following table summarizes the
battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
PLACE IN CHARGER
.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
until the screen shows
LOW BATTERY or HANDSET X
(at least 30 minutes).
The screen shows
LOW BATTERY
and ashes.
Battery has enough charge to
be used for a short time.
Charge without interruption
until the screen shows
HANDSET X (at least
30 minutes).
The screen shows HANDSET X
and the battery icon shows
, or .
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
notes:
If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
If no battery is installed in the handset when you place it in the telephone base or charger, the
CHARGE
light is o and the screen shows NO BATTERY. Follow the instructions in Battery
installation on page 4 to install the battery.
•
•
HANDSET 1
16 MISSED CALLS
10:30PM
11/20
Battery status icon

AT&T EL52310 Specifications

General

Brand	AT&T
Model	EL52310
Category	Cordless Telephone
Language	English