AT&T EL52413 User Manual

6 7
Battery
Install the battery, as shown below.
Caution: Use only the supplied rechargeable battery or replacement battery
(model BT162342/BT262342).
Charge your handset(s) before initial use. The battery is fully charged aer 16
hours of continuous charging. The CHARGE light on the top of the handset is on
during charging.
Install
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles
BT162342/BT262342
(2.4V 300mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
BY1021
THIS S
Battery Pack / Bloc-pil
BT162342/BT262342
(2
WARNING / AVERTISSEMEN
DO NOT BURN OR PUNCTURE
NE PAS INCINÉRER OU PER
Made in China / Fabriqué
CHARGE light
Wall-mount installation (optional)
Plug the telephone line into
the telephone base.
Align the holes on the wall-
mount bracket with the
standard wall plate.
Slide the wall-mount bracket
down until it locks securely.
Plug the power adapter into a
power outlet not controlled by
a wall switch. Plug the other end
of the power adapter into the
telephone base.
1
2
3 4
Insert the extended tabs of the
wall-mount bracket into the slots
on the back of the telephone
base. Push the telephone base
down until it is securely in place.
A DSL lter (not included)
is required if you have DSL
high-speed Internet service.
A DSL lter (not included) is
required if you have DSL
high-speed Internet service.
DSL lter

AT&T EL52413 Specifications

General

Brand	AT&T
Model	EL52413
Category	Cordless Telephone
Language	English