AT&T MERLIN Plus System Planner

System Planner
Date
Name
Address
Phone
DOSS Order No.
The information you supply on the enclosed forms will enable your AT&T Service Technician to install
your new MERLIN Plus Communications System so that it works exactly as you want. It is important
that you provide this information prior to installation.
In addition to installing your system, the Service
Technician will train someone from your company to use it, so you must have someone present during the
installation.
What is the name and phone number of the person who will be present when your system is installed?
Name
Phone
DIAL SIGNALS
LONG DISTANCE DIALING
TRANSFER RETURN
INTERVAL
CALL REPORT
Fill out the attached System Planner Configuration Form, including the Voice
T erminal Assignment section, using the following guidelines:
Under Dial Signals, check one of the following:
● Touch-Tone —if all of your telephone lines are Touch-Tone lines
● Rotary (Pulse) —if one or more of the lines are rotary-only lines
Under Long Distance Dialing check one of the following:
● Toll-Prefix —if you have to dial a 1 or 0 before the area code when making
a long distance call
● Area Code Only —if you don’t have to dial a 1 or 0 before the area code
Under
Transfer Return Interval, check one of the following:
● N O Return —if you don’t want transferred calls returned to the originator
●
Rings —if you want transferred calls to return after more or less than
four rings which is the default (fill in the blank with the appropriate
number —up to nine rings)
Under
Call Report, complete the following if you have the optional data
collector and printer:
●
●
Put a check mark in the box next to Outgoing Calls Only if you want to
record only outgoing calls.
Put a check mark in the box next to Incoming and Outgoing Calls if you
want to record both incoming and outgoing calls.
System Planner 1

AT&T MERLIN Plus Specifications

General

Brand	AT&T
Model	MERLIN Plus
Category	Conference System
Language	English