AT&T MiFi 2372 - TCP;IP; Router Settings; DHCP Server Enable

52
TCP/IP
The TCP/IP page allows you to view the IP address and the MAC address for your MiFi device.
➤ Choose Router > TCP/IP from the menu bar.
The TCP/IP page opens.
This page gives you the following status information about your device:
• IP Address — The address that identies the MiFi device on the network
• Subnet Mask — The standard address for the MiFi device subnet.
• MAC Address — The physical address or hardware address of your MiFi device.
• DHCP Address Range — The range of IP addresses assigned by the MiFi DHCP server.
Router Settings
The Router Settings page allows you to enable DHCP and allow VPN passthrough.
➤ Choose Router > Settings from the menu bar.
The Router Settings page opens.
DHCP Server enable
The DHCP Server allows the device to automatically assign a local IP address to a new device joining
your network (such as a wireless printer or another computer). Without the DHCP Server enabled,
you have to assign static IP addresses to all devices on your network.
➤ Select or deselect the check box to enable or disable the DHCP server and then click Apply.