AT&T SynJ SB67138 - Adding and Managing Devices

Getting started
Add and register handsets
Your telephone can support up to 10 cordless handsets, or nine cordless handsets
and one cordless headset. You can add new handsets and headset (AT&T models
SynJ SB67108 and TL7600, sold separately) to the SynJ SB67138 at any time, but
each new handset or headset must be registered with the telephone base before
use. You must register each handset and headset separately.
The handset provided with your SynJ SB67138 is already registered as
Handset 1. Additional handsets are assigned numbers in the order they are
registered (Handset 2 to Handset 10).
If the handset does not have enough power to proceed with
the registration, you need to charge the new handset for at
least five minutes (see Battery installation and charging in
the SynJ SB67108 cordless handset manual). Start registration
when the handset screen shows Press MENU on BS, sel
Registration & sel Register HS. Then put HS in cradle.
Press MENU on BS,
sel Registration
& sel Register
HS. Then put HS
in cradle.
10
To register a handset to your telephone base
1. Make sure the handset is out of the charger and the
screen shows Press MENU on BS, sel Registration & sel
Register HS. Then put HS in cradle. before you begin
registration.
2. On the telephone base, press MENU/ENTER.
3. Scroll down to Registration and press MENU/ENTER.
4. Press MENU/ENTER again to select Register HS.
5. Place the unregistered handset into the charger. The
telephone base screen shows Registering new device....
It takes up to 60 seconds to complete the registration.
There is a beep sound when the registration is successful.
The telephone base shows Handset registered and
then the handset shows X:Handset X (X represents
the extension number [1-0]; Handset X represents the
handset name).
NOTES:
If the registration is not successful, the telephone base screen displays
Registration failed with an error tone. To reset the handset, remove the handset from the
cradle. Try the registration process again.
Make sure to remove all unregistered system handsets or cordless headset from the cradles
before registering a new handset.
1.
2.
COVM
Speed dial setup
Customer support
Registration
>
Register HS
Deregistration
>
Registering
new device...
Handset
registered
2:Handset 2
Set date & time
Charging