AT&T SynJ SB67138 - Volume Control; Ringer Tone

Ringer tone
Use this feature to choose one of the seven ringer tones for incoming calls.
You can choose different ringer tones for different lines so you can easily
identify which line is ringing.
When the telephone is idle, press MENU/ENTER.
Press or to scroll to Ringer setting. Press MENU/ENTER.
Press or to scroll to Ringer tone. Press MENU/ENTER.
Press REP or SKIP to select the desired line (L1, L2,
L3 or L4).
Press or to select a desired ringer tone.
Repeat steps 4-5 above to choose ringer tones for other
lines if desired.
Press MENU/ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press EXIT.
NOTE: If you turn off the ringer volume, you will not hear ringer
tone samples.
1.
2.
3.
4.
5.
6.
7.
Directory
Call log
Ringer setting
Mailbox setup
>
Ringer volume
Ringer tone
Ringer group
>
Ringer tone
L1 L 2 L3 L 4
1 1 1 1
Ringer tone
L1 L 2 L3 L 4
1 3 1 1
Volume control
Use this feature to independently set the listening volume
to one of five levels for each of the three listening options
(corded handset, speakerphone and corded headset). While
using each, press , , VOL+ or VOL- to adjust the
listening volume.
While using the volume control, you hear a triple beep
when you reach the minimum or maximum level.
The SynJ SB67138 telephone base stores the volume setting for each
listening option.
Getting started
Telephone base setup
15
Volume